For this project u will need simple tools and parts
check my other instructables and the latest one is how to make a spud gun
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Things U Will Need
hot glue gun and stick
soldering wire and rod
mini drill or any sharp pointy thing to make holes
nose tip plier
Step 2: Making the Leds Circuit
the leds should be solder in parallel as shown in the diagram
Step 3: Drilling and Placing the Circuit
drill two holes for the leds it depends on u where your leds poles come next solder the poles with wire and a switch
Step 4: Holder
in this one band will be used to hold ur battery and other for ur hand repulsor
1-MAKING BAND FOR YOUR BATTERY-
u will need velcro for this ,make sure that the rough part of the velcro must be shorter than the other one
now to stick it one side of the velcro should be on the opposite side of the other velcro
see in the diagram
2-making the band for your palm -
cut a cardboard which is smaller than your palm
next glue the velcro on the sides of the remember u should place the velcro the same as u placed in the previous one and the length of the velcro must hands breadth size .
at the center of the card board place the the bottle cap.
Step 5: TESTING IT!!!!!!!!!!!!!!!!!!!!!!!
lets see how it looks in dark
Participated in the
Make It Real Challenge