How to Make a Wooden Fingerboard

Introduction: How to Make a Wooden Fingerboard

Step 1: Gluing Venner

get 5 peaces of venner and glue them togheter and put it un your mold or 2 teach decks then clamp the 2 teach decks or mold togheter and wait 12 hours or over night 

Step 2: Cutting the Deck and Sandig

when you take your deck out of the mold you will cutt it whit cissors or rufcutt the sand it down so it will get smoth 

Step 3: Drilling the Holes

take a teach deack and place it over your deck the use the 1.16 inch drill bit to drill the holes
then take the 1.8 drill bit and drill into the holes but not all the way thru the get som grip tape and put on and trucks and shred it =)

Participated in the
Gorilla Glue Make It Stick Contest

Be the First to Share

    Recommendations

    • Puzzles Speed Challenge

      Puzzles Speed Challenge
    • CNC Contest 2020

      CNC Contest 2020
    • Secret Compartment Challenge

      Secret Compartment Challenge

    7 Discussions

    0
    OffBeatSocker

    How could you cut 5 ply of glued veneer with scissors? I'm pretty sure you didn't even make it cause of the limited amount of pictures.

    0
    simbafingerboards
    simbafingerboards

    Reply 5 years ago on Introduction

    veneer is really thin i advice you to not do as i wrote when i was 10 firstly glue the venner and then when its has dried you cut sand it down or cut it

    0
    simbafingerboards
    simbafingerboards

    Reply 5 years ago on Introduction

    English wasnt my main language im 15 now and i live in sweden dont blame me haha

    0
    knuckleboy
    knuckleboy

    6 years ago on Introduction

    The funny words:

    peaces, venner, un lol, whit, smoth, teach deack, 1.18 lol it's so big