IPhone Charging Sleeve

Introduction: IPhone Charging Sleeve

Ever need to charge your phone but there is no table near by? If so you came to the right place. This invention allows the charger to hold the phone. The phone is held by a duct tape holder that attaches to your charger. This invention is very user friendly and will take about five minutes. Enjoy.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Step 1

first gather materials. You will need duct tape, any charger, the cable, scissors and the device.

Step 2: Step 2

Get a good sized piece of duct tape.

Step 3: Step 3

With the piece of duct tape you just tore off fold it in half.

Step 4: Step 4

Fold that piece again in half.

Step 5: Step 5

With the same piece fold the side you want to attach to the charger.

Step 6: Step 6

Cut a half circle in the side you just folded.

Step 7: Step 7

Unfold the the part to reveal the circle.

Step 8: Your Good to Go!!

Put the circle part around the plug and plug into the wall. Then put your phone inside the bottom of the duct tape.

Be the First to Share


    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Raspberry Pi Contest 2020

      Raspberry Pi Contest 2020
    • Wearables Contest

      Wearables Contest

    3 Discussions


    5 years ago

    Duct tape can have aluminum and can conduct electricity. I'd coat the hole with electrical tape to prevent accidents!