Introduction: Knex Micro Uzi
this is one of the best micro uzi's I've seen on the site because of it looks and it's size.
al the other uzi's where big or didn't look like a micro uzi. I don't know how far it shoots but it isn't to far because i only use 3 little rubberbands.
a few pro's and cons
it looks like a real micro uzi
it doesn't need much parts
you don't have to cut in parts
it isn't really strong(the barrel is ripped apart sometimes)
it doesn't shoot so far
i think i can be proud of my first instructable and gun!!!
PS. I'LL UPDATE THE MAIN IMAGE SOON BUT THIS ONE IS TOOKEN BY MY WEBCAM.
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: What You Need
a few rubberbands
a pair of scissors
tape (I prefer ducttape)
and the parts on the 3 pictures
Step 2: The Gun Handle and Sides
pic 1&2 built these 2 sidepanels and the other 4 panels.
pic 3 then built the two innerpanels.
pic 4 attach the panels with a blue rod with two beige connectors. put one in the other hole too.
pic 5 attach the innerpannels with the two blue rods and put in a blue rod on the front as showed.
pic 6 overview till now
Step 3: The Barrel
pic 1&2 this is the first part of the barrel. you have to do it with these two pictures.
pic 3 put the barrel in the back of the gun
pic 4&5 wrap this together with some tape and cut out the holes. then turn the y connector and put this piece on as shown. then turn the barrel back in the gun.
Step 4: The True Trigger
pic 1 this is the trigger i stole it from the glock 23 from ironman but you dont have to cut of the rods! :) !
pic 2 this part is to prevent falling out the trigger.
Step 5: The Ram
make this ram and wrap some tape around it so it doesnt break down when you shoot.
Step 6: The Rubberbands
this is where to put the rubberbands
Step 7: Finish
I HOPE U LIKE IT AND PLEASE RATE AND SUBSCRIBE