Knex Pistol

7,031

6

29

Intro: Knex Pistol

ok this is basically like any other knex pistol and quite power depending on how many elastic bands you use.

Step 1: The Barrel

this is the barrel of the pistol, the pictures are self explanatory.

Step 2: The Firing Pin

this is the firing pin. Make sure to tape the end of the firing pin up. If you do not have the piece at the end of the pin the it can be replaced with an orange connector.

Step 3: The Cover

this is a cover/handle for the gun

Step 4: The Handle

this is the handle of the gun

Step 5: Putting It All Together

pic 1: insert firing pin
pic 2-4: add elastic bands
pic 5,6: add cover and extra white rods
pic 7: add handle

Step 6: Loading and Firing

pic 1: pull back firing pin
pic 2: load bullet until it clicks and won't fall out
pic 3: push trigger

Share

    Recommendations

    • Optics Contest

      Optics Contest
    • Plastics Contest

      Plastics Contest
    • Audio Contest 2018

      Audio Contest 2018

    29 Discussions

    0
    None
    James Godfir

    9 years ago on Step 5

    I'm slightly confused by the amount and placement of the rubber bands. I'm guessing it's three, and I can't tell where you put them on the other side.

    0
    None
    hoi

    9 years ago on Step 5

    how do you make the elestic bands on the other side of the firing pin???? and what do you do with the little black stick behind the yellow thing???? I don't understand.

    0
    None
    instructa-fan

    11 years ago on Introduction

    You're gonna go to jail and be good enoubh to where you order Knex out of that jail catalog, make this, and get a life sentence. Thumbs Up. Get-R-Done.Giggity Goo. Alll Riiiggghhht.

    7 replies
    0
    None
    DrWeird117

    10 years ago on Introduction

    Haters whose droning request for the list are much more annoying than block triggers. Copy and paste if you agree.

    0
    None
    pls

    10 years ago on Introduction

    looks like killerks gun and its a block trigger