Knex Robot Arm

A lengthening for your arm

I am from belgium so my english isnt so good... sorry

for mlcad users:
http://www.mediafire.com/?vvohy2ztyaf

Step 1: 1e Piece

1e pice

pic. 3: replaceable by yellow one`s

Step 2: 2e Piece

2e piece

pic. 2: replaceable by red one´s

Step 3: 3e Piece

3e piece

Step 4: 4e Piece

4e piece

Step 5: The Big Rod

very importand

Step 6: The Claw

....

Step 7: Link Everything

pic. 6-8: where to connect the rod
pic. 9: ad some rubber bands

Share

    Recommendations

    • Remix Contest

      Remix Contest
    • Build a Tool Contest

      Build a Tool Contest
    • Warm and Fuzzy Contest

      Warm and Fuzzy Contest

    37 Discussions

    0
    None
    Gizmoguy45

    2 years ago

    I MADE TWO!!!!!!

    0
    None
    Gizmoguy45

    2 years ago

    best knex instructions I have seen on this website

    0
    None
    99igo

    8 years ago on Introduction

    Where do you put the rubberbands? Please reply. (I sucribed and rated 5 stars)

    0
    None
    99igo

    8 years ago on Introduction

    DUDE. DIS IS FRICIN AWSOME !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!:)

    0
    None
    aleceatsfood

    8 years ago on Step 7

    awesome!! I like it but it's kind of hard to make it open again but I'm suprised that there is no rubber bands used! very well done 5*

    2 replies
    0
    None
    dansdoc

    8 years ago on Step 2

    replace the red rods for a diferent size and make th big rod a different size?

    1 reply
    0
    None
    stopanator

    9 years ago on Step 7

    i made it its fun but one thing it somtimes bends when i pick p my remote