Knex Flip Target

About: none of your business

this instructable shows how to make my target that flips down. Parts list:
connector
orange connector: 7
grey connector: 5
lavender 3-d connector: 4


blue rods: 6

misc
tan clip: 1.
Happy building and New year!

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: The Target

this step shows how to make the target that you hit.

Step 2: The Axle

this step shows how too make the axle

Step 3: The Base

this step shows how to make the base.

Step 4: Putting It All Together

this step shows how to put it all together.

Step 5: Your Done!!!!

yay! your done! have a fun time with my knex flip target.

Be the First to Share

    Recommendations

    • CNC Contest

      CNC Contest
    • Teacher Contest

      Teacher Contest
    • Maps Challenge

      Maps Challenge

    17 Discussions

    0
    None
    lilnorm123

    10 years ago on Introduction

    if you connect the blue connectors in the angled slot and replace the blue rod on the axle with a white rod it works better

    0
    None
    ol987986

    10 years ago on Introduction

    betta dan some of the targets i tried, i built one, shot it and mi yellow rod snapped lol!

    0
    None
    The Jamalam

    10 years ago on Introduction

    not bad, although you could have made it so you dont have to go and reset it every time. Not bad though, 3.5stars

    2 replies
    0
    None
    FutJJThe Jamalam

    Reply 10 years ago on Introduction

    im bussy with that, with a rope and some rubberband tricks, pretty hard, cus you have to make the target on the table, otherwise you put the hole target with it xD