this is my first instructabele!
if you wonder why this are pretty bad, because my budget has been blown this month buying an xbox to mod.
and everything you need for this project is:
9 v battery (mine was used so it had only around 5-6v)
double sided tape and a knife
Led ( you can oci the color^^)
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Preparations
what you need:
double sided tape and knife
9 v battery
Step 2: Assembly
cut out a decent amount of double sided tape and put it on the battery
*Tip before you attach it to the wall, make sure the tape can be taped to the wall*
Step 3: Add Led
The light emitting diode has two legs, the cathode and the anode.
the cathode is minus and has a shorter leg, and the anode has a longer leg.
so the cathode should be put inside the -pole of the battery, and the anode should be put in the +pole of the battery
if you have done it right, the led should light up, if not, try to reverse the diode.
alternative, check the battery
Step 4: Result
look how awesome it lights up a small area.
once again, sry for the bit of lame project, but my budget wasn't good this month because of the xbox...