LittleBits Halloween Prank

Introduction: LittleBits Halloween Prank

This fun little project is just in time for Halloween. Use this project to scare or amuse your friends when they get too close to your treat bag.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Gather Your Materials

Craft Materials:

Medium sized novelty pumpkin (we found one at the dollarstore)

Cardboard

Tape

Glue gun and glue

LittleBits:

Power block, button, buzzer, servo motor, 1 orange wire, RGB light


Step 2: Assemble Your LittleBits

Assemble your littleBits in the following order:

Power block, button, buzzer, servo motor, 1 orange wire, RGB light

Step 3: Attach Your LittleBits

Tape your RGB light to the front of your pumpkin where the jack-o-lanturn's face is located.

Tape a circle of cardboard to the servo motor, then hot glue the cardboard to the bottom of the pumpkin.

Step 4: Attach Your Pumpkin to the Table

Attach the servo motor to a table using tape and enjoy scaring your friends :)

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge
    • Arduino Contest 2020

      Arduino Contest 2020

    Discussions

    0
    wilgubeast
    wilgubeast

    5 years ago on Introduction

    Good timing. Get your Halloween pranks in early, as we open the Halloween contests to anything Halloweenie from the year prior. :D