Mini Quad Rebuild on Laser Cutter( Hubsan X4 )

1,895

36

1

Ok so i made this Quad frame from card-bord that was going to the trash at Fablab in Odense. i used the lasercutter at the lab to cut the frame in to 2D pices, glue them on top. and lust fit in the elektroniks and you are up in the air as cheap as it get's... freebii!!!!!!

hop it can inspirer you.

thanks to http://www.fablabinnovation.dk/(Fablab Odense ) for the gurilla workshop on Onsdag from 10-18

that is for this time, until we're back.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Be the First to Share

    Recommendations

    • Furniture Contest

      Furniture Contest
    • Reuse Contest

      Reuse Contest
    • Hot Glue Speed Challenge

      Hot Glue Speed Challenge

    Discussions