Nerf CS-6 Dart Tag

Introduction: Nerf CS-6 Dart Tag

How to make a streamlined dart (a CS-6 dart) for playing dart tag out of a normal dart tag dart!

Step 1: Intro and Supplies

First I would like to apologize for the poor images.

Ok, I haven't range tested my darts but I have made sure that the longshot can fire it and attach to the dart tag vest.

Supplies:
A nerf gun ,DUH,
dart tag dart,
scissors
glue
x-acto knife

For some reason it won't let me add image notes!
2nd pic left to right:
dart tag dart, dart tag modded to streamlined, the dart
I'm making, a streamlined dart.

Step 2: Step 1:

Use your knife to cut the top off the dart tag dart. Make sure to leave the bottom of the dart tip intact, there should not be a hole. If you did or did not cut to low, continue to the next step.

Pic.1: My knife in the dart.
Pic.2: A decapitated dart.

Step 3: Step 2:

Now trim the edge of the rubber off the dart tag dart.

If you cut too low in the privios step or this step,like I did, seal the hole with glue.

Step 4: Step 3:

Now take the dart tip you cut in step 1 and cut out a square of the velcro. Take this square and glue it to the tip of your new streamlined dart. If you want, keep the xtra pieces of velcro to mod stock streamlined darts.

Be the First to Share

    Recommendations

    • Mason Jar Speed Challenge

      Mason Jar Speed Challenge
    • Bikes Challenge

      Bikes Challenge
    • Remix Contest

      Remix Contest

    10 Discussions

    0
    cool aclaim4
    cool aclaim4

    11 years ago on Introduction

    AAARRRGGGHHH!!! can't find the longshot anywhere in the uk. anyone know where to get it

    0
    mc thumbs
    mc thumbs

    10 years ago on Introduction

     How old are you cool aclaim4?

    I got along shot when I was six.

    0
    wizerd 745
    wizerd 745

    Reply 10 years ago on Introduction

    I think you sent the message to the wrong person  >.>