Introduction: Origami Dragon (Flame Dragon)
Hello:D this dragon was created by my self and the name is flame dragon because the tail like a fire.I wish you like it and you did it
Step 1: Materials:
Step 2: Making the Base
1.make a bird base
2.follow the diagram
3.push the square and follow the diagram
Step 3: Making the Body
WOOOW....lots of instruction huh?
ok.
follow the instruction care fully and i foggot to put 1 instuction watch the up what i did sorry :D
Step 4: Making the Back and the Tail
..........................no comment
Step 5: Make the Head`using Another Paper But Small
1.then,`TAKE A SMALL PIECE OF PAPER TO MAKE THE HEAD`
2.sorry i skip it.make a waterbomb base
3.follow the diagram.
4.after we crease, put what we crease and put it inside so it become square like the diagram.
5.make a bird base.
6.fold it down
7.fold it like at the diagram
8.close it
9.follow the diagram
Step 6: Last Step:asslembling the Heat to Body
1.before that,put the beak down just little bit.
6.put the head to the neck and close it