I Atempted to make a ammo holder like the one here
It turned out great so i decided to make step by step direction on how to make 1
This project compatibable with the longshot and can be done totaly with out a recon so dont fret LS owners
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Materials
- longshot or recon
- longshot front gun or recon barrel
- dart tag 8 round revolver
- screw driver
- hot glue
tools (* required)
- *Drill or drill press
- *1 1/2" drillbit
- *zacto balade or razor
- band saw
- sand paper (or a belt sander)
(a drill press, zacto, belt sander and band saw but it could be done with the other tools)
Step 2: Dissasembly
Dissasemble dart tag blaster and recon barrel (or long shot front gun)
Step 3: Construction
pic 4 notice how it dosent fit i took a belt sander and sanded the sides of it to make it fit flush,
but i did not remove the 2 hooks on it
pic 5 sorry for the blur but when sandes down hot glue into place
******* plach a small bead of glue onto the spot shown but only when in allined with the smaller groove on the circle piece
Why the bead of glue?
well if you dont know y but its to cause friction to keep the atachment in place and not rotate and fall of by natrual movements. (on the recon barrel atachment there is a spring loaded pin that hooks into a grove into the gun...same concept)
Step 4: All Done
its taken 30 min to an hour to build and its now completed!!!
*Special thanks to
the dude who came up with it GO HIM