Rubber Band Powered Air Car




Mterial required:

  • Rubber Bands
  • 2 Plastic bottles
  • Pocket knife
  • 4 caps
  • Glue gun
  • Sticks

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Cutting Bottles

Take one plastic bottle cut the upper surface on the bottele 6¨ along with the bottle and 2¨width with the help of knife as shown in the pitchure.

Step 2: Making Holes

Make 4 holes on the opposite portion of the cutted part for inserting sticks for wheel.

Step 3: Making Air Propeller or Fan

Take one more bottle and cut top portion of the bottle and cut it as slices,now tilt cutted slices as proppellerr or fan.

Step 4: Inserting Fan to Body

now take one cap and make one hole at the center of the cap for inserting stick or shaft. After sticking put some glue and take one more cap and make it as plate now insert it one inch infront of the cap and glue it for stiffeness.Now make one hole at the top of the bottle for inserting shaft, at the end of the stick or shaft make one rectangle notch for tagging rubber band tag 6 rubberbands togather along with the length of the bottle and put cap on the rubberband. Now rotate the shaft from this rubberband going tilt now your car is ready to go.

Step 5:

Be the First to Share


    • Furniture Contest

      Furniture Contest
    • Reuse Contest

      Reuse Contest
    • Hot Glue Speed Challenge

      Hot Glue Speed Challenge

    3 Discussions


    3 years ago

    Oh mother what bad grammer :) WEELL i still learnes somethin good joob

    1 reply

    Reply 2 years ago

    Oh mother, what bad grammar. :) Well, I still learned something. Good job. **


    2 years ago

    What is step 5?