Shower Stall Remove and Replace 3 of 7

Introduction: Shower Stall Remove and Replace 3 of 7

About: http://www.coolplumbingvideos.com These " How to" Plumbing videos are a must. Even if you feel you know everything there is to know about plumbing repairs, there is something in these videos for you. Just ...

Remove old shower stall and install new shower stall. Cut water to house off or if there are cut off behind the tub cut it off there. Carefully remove the old tub and shower valve. Remove handle, and esuction plate. Cut old valve out from the back side wall Clean work area and begin prepping the new tub and shower valve for installation. Begin install putting the new tub and shower in place and solder together , then come back to the tub side of the faucet in install the tub a shower trim.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge
    • Finish It Already Speed Challenge

      Finish It Already Speed Challenge

    Discussions