Shower Stall Remove and Replace 6 of 7

About: http://www.coolplumbingvideos.com These " How to" Plumbing videos are a must. Even if you feel you know everything there is to know about plumbing repairs, there is something in these videos for you. Just ...

Remove old shower stall and install new shower stall. Cut water to house off or if there are cut off behind the tub cut it off there. Carefully remove the old tub and shower valve. Remove handle, and esuction plate. Cut old valve out from the back side wall Clean work area and begin prepping the new tub and shower valve for installation. Begin install putting the new tub and shower in place and solder together , then come back to the tub side of the faucet in install the tub a shower trim.

Share

    Recommendations

    • Sensors Contest

      Sensors Contest
    • Classroom Science Contest

      Classroom Science Contest
    • Beauty Tips Contest

      Beauty Tips Contest

    Discussions

    0
    None
    BluesRider

    7 years ago on Introduction

    Sorry dude,but once again,you didn't show the hard part of this segment,which is soldering the unit to the supply lines,without setting the wood framing on fire.