Snowman Christmas Ornament

Snowman Christmas ornament

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Step 1

I started by using three of the sphere's making the first the biggest and the second smaller than the first but bigger than the third,the third sphere is going to be the smallest of the three spheres.

Step 2: Step 2

I moved the spheres on top of each other.

Step 3: Step 3

Then I made a box for the base of the hat and moved it on top of the smallest sphere and rounded the corners of the rectangle.

Step 4: Step 4

I put a cylinder on top of the base of the hat to make it a hat.

Step 5: Step 5

Then I extruded 10 little circles to make the eyes ,mouth, and the buttons.

Step 6: Step 6

I used a cone to make the nose.

Step 7: Step 7

I extruded a cylinder through the hat so that you could put a hook or a string through it to put it on your tree.

Step 8: Step 8

3D Printed Ornament Design Challenge

Participated in the
3D Printed Ornament Design Challenge

Be the First to Share

    Recommendations

    • Made with Math Contest

      Made with Math Contest
    • Cardboard Speed Challenge

      Cardboard Speed Challenge
    • Multi-Discipline Contest

      Multi-Discipline Contest

    Discussions