this is pretty cool, the first ever pressure detonator on this site. its really cool. basicly u step on it and it EXPLODES!!! designed to be used with my airsoft landmine

Step 1: Obtian Materials

the stuffs you will need will be as follows:
wire
6 or 9 volt battery
cardboard
electrical tape
paper clips

Step 2: Make the Pressure Circut Compleater: Part One

make the push part:
attach one end of one of the wires to a paper clip with electrical tape and then insert a small strip of cardboard into the paperclip.
it really helps if these paperclips are big.

Step 3: Make the Pressure Circut Compleater Part 2:

make the pressure compleater base.
attach a paperclip to the end of the second wire and then tape it sideways to the cardboard, under the item compleated in part one, which was also taped to the cardboard base layer. the two paperclips, when placed together, should be perpendicular, or at 90 degree angles.

Step 4: Add the Weak Supports

the next step is to take two weak paperclips and stick them on the sides so that they will hold up the top part but will easily bend when steped on. srry no pic

Step 5: Split the Wire to Add the Clips

next is split one wire leading to the circut and add aligator clips. note that i used paperclips not aligator clips cuz they were on my remote detonater.