Introduction: Toilet Paper Tube Airsoft Gun Silencer
Hello, this instructable is on my way of making a silencer for my kjw 1911a1.
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Parts
1 Toilet paper tube
1 6x6 in. sheet of cardboard
1 Bottle of superglue
1 double sided tape
Step 2: Cutting Circles
Get your tube and trace out the diameter on to the cardboard four times. Cut them out and glue three of them together and save one
Step 3: Finishing
Now you make a hole in one end of the circle on the thicker one that fits snugly over the tip of your barrel and an even bigger hole in the thin one.You then put the thicker one in one end and glue it in. Make sure it fits snugly. Then you put the thin one in the other end and glue it in.
Step 4: Putting It On
Step 5: Finish
Thats how you make a silencer out of a toilet paper tube for an airsoft gun.
Note: This is a MOCK silencer, it wont quiet your gun.
Participated in the
Unusual Uses: Bathroom Challenge