Wall Following Virobot

Introduction: Wall Following Virobot

About: I love robots but don't have any money to buy parts normally so, I take apart anything I can, and find cheep ways to do something expensive. I am very fluent in python and know the basics of action-script an...

In this Intstuctable I’m going to show you how to make a very simple virobot that follows the wall.This project is super easy to build. This robot like any virobot uses one motor to vibrate the stand or in this case the Styrofoam moving the whole robot, The robot we will be making can follow the wall or go around objects(as long as it isnt on carpet) .  This project is free if you have taken apart enough toys and saved the parts.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Materials

What you need for the project is:

     Motor with a weight (the motor in the picture is not the motor I used)

all this stuff was from taken apart toys.
but if you are rich and want to spend the money you can get this stuff at a hobby store.

Step 2: Adding the Battery and the Motor on the Body

this step is easy just put tape on the sides of the battery and motor.

Step 3: Wiring

this step sounds easy enough to do without explanation but just in case I made a pictue of what it should look like. but I should mention that you can change the way the DC motor is rotating by changing the wires around.

Step 4: Finished!

Slap a nice piece of paper on the back and your done. you can also tape a marker on the back to have it draw. Have fun with it!

Be the First to Share


    • Magnets Challenge

      Magnets Challenge
    • Raspberry Pi Contest 2020

      Raspberry Pi Contest 2020
    • Wearables Contest

      Wearables Contest

    2 Discussions