Water Tank Automation - Prototype

About: embedded system enthusiast ...
micro controller based water tank automation   12v prototype
  •      8 LED  level indication
  •     12v dc water pump
  •      pic16f877a micro-controller

http://www.youtube.com/watch?v=fe4I3bVfs-A&feature=youtu.be

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Supercharged Contest

Participated in the
Supercharged Contest

Make It Glow Contest

Participated in the
Make It Glow Contest

Share

    Recommendations

    • Indoor Lighting Contest

      Indoor Lighting Contest
    • Make It Fly Challenge

      Make It Fly Challenge
    • Growing Beyond Earth Maker Contest

      Growing Beyond Earth Maker Contest

    10 Discussions

    a three line code

    while(1)
    {
    PORTD=~PORTB;
    if(RB0) RC4=1;
    else if(!RB7) RC4=0;
    }

    0
    None
    eric.1

    1 year ago

    Hello is it possible to do it for a drilling of 13 meters with a graduation smaller than

    on the video and it possible to have that the level of the water in figure andcut of the pump

    if level too low and how much does it cost if you sell i



    Sorry, I'm French and I do not speak English well I do with a trainer



    best wishes for this new year 2018



    cordially Eric

    0
    None
    ankesh4040

    2 years ago

    Will this model work if i fill it with pure water. Or do this model require specific type of water to work? How is the water level detected. Which part(device) is detecting water level

    0
    None
    ankesh4040

    2 years ago

    Will this model work if i fill it with pure water. Or do this model require specific type of water to work? How is the water level detected. Which part(device) is detectibg water level

    0
    None
    sagarmy

    5 years ago on Introduction

    Hi Jestin , Your project is great can you sent me the circuit diagram and code for it.

    0
    None
    Saitu

    5 years ago

    This is brilliant!! Please give the schematics and directions to make it!