Wire Hanger Bow




this bow needs 1 hanger 1 long rubber band and duct tape. this bow can shoot up to 40 feet.

Step 1: Straighten the Hanger

For this step you have to straighten the hanger by unskrewing the hanger.

Step 2: Bend It in Half

Now you have to bend the hanger in half.

Step 3: Tape It

now you have to tape the bow

Step 4: Bend the Bow Into It's Shape

now you have to bend the bow into a bow's shape(half a circle).

Step 5: Bend the Ends

now take each end and bend it into a v shape.

Step 6: Putting on the Rubber Band

now put the rubberband



    • Pocket Sized Contest

      Pocket Sized Contest
    • Trash to Treasure

      Trash to Treasure
    • Arduino Contest 2019

      Arduino Contest 2019

    5 Discussions


    Reply 10 years ago on Introduction

    for ammo take a 3 ft dowl and cut it in 1/2 then sharpen 1 end in a pencil sharpener and on the other end cut a notch for the rubberband to go in ......and then u have an arrow