this is a 7 shot knex revolver with a rotating block trigger. i got the idea for this gun when i looked at syprans revolver and thought that it would be better with a trigger. it is quite unreliable because of the the revolving magazine made from spacers and duct tape.

please comment even if you criticise it.

Step 1: Handle

look at the picture

Step 2: Modified Piece

i made this from a broken one but youl just have to cut it with a craft knife

Step 3: Body & Barrel

look at the picture

syprans revolver

Step 4: Assembly

look at the picture

Step 5: Firing Pin

you can alsoalso use a red rod

Step 6: Loading and Firing

place white connectors in the magazine as shown then pull back the firing pin until the trigger moves in front of it then rotate the magazine anti - clockwise until one of the white rods is in the modified piece. i used 2 rubber bands but it does put a fair bit of strain on the red rod.

Step 7: Thanks for Watching :)

please leave a comment

Introduction: Knex Revolver