Introduction: Knex Target Pistol
I have to say that this is a pretty good gun.
it's very fun to shoot at stuff with it.It can pierce cardboard
Step 1: Barrel and Barrel Support
this step shows how to make the barrel and its suport
Step 2: Trigger and Handle
this step shows how to make the trigger and handle
Step 3: Attatching Rubberbands
this step shows how to attatch the rubberbands
Step 4: Ammo
grey rod attached to a red connector
Step 5: Your Done!!!!!
your finished now go have fun with my gun!
16 Comments
15 years ago on Introduction
You stole my Panther Pistol. Just look in profile. It's been there for like two months.
Reply 15 years ago on Introduction
Just look in *my* profile.
Reply 13 years ago on Introduction
then you copied the, *sipriani*.
Reply 15 years ago on Introduction
no I didnt
14 years ago on Introduction
Theres no pictures for step 4.
Reply 14 years ago on Introduction
Did you read what it said?
Reply 14 years ago on Introduction
Grey rod attached to red connector..?
Reply 14 years ago on Introduction
fine,I'l make you a pic...
Reply 14 years ago on Introduction
Yaay, thanks!
Reply 14 years ago on Introduction
are you happy now?
Reply 14 years ago on Introduction
i know that...
Reply 14 years ago on Introduction
were you trying to make extra work for me?
Reply 14 years ago on Introduction
haha no.
15 years ago on Introduction
good gun i made 2 out of my pieces regular colors and mettalics
15 years ago on Introduction
making the barrel longer is a modification to think about
Reply 15 years ago on Introduction
Agreed:)