K'nex/bb Shooter
Intro: K'nex/bb Shooter
Dont know how far it shoots, but its not bad.
STEP 1: Step One.
just make this. easy-peasy.
note: these are 8 dark grey one-slot connectors.
note: these are 8 dark grey one-slot connectors.
STEP 2: Step Two.
also easy.. just make it:)
STEP 3: Step Three
Assemble these two.
STEP 4: Step Four.
make these.
STEP 5: Step Five
Pic 1: put it on the back.
Pic 2: assemble the blue sticks with the red connectors on it.
Pic 2: assemble the blue sticks with the red connectors on it.
STEP 6: Step Six.
put one grey 1 slot connector behind the back stand.
STEP 7: Step Seven.
Bend the rods so they're only with the back on the ground.
Note: the orange thing at the top isnt made yet:D
Note: the orange thing at the top isnt made yet:D
STEP 8: Step Eight. Almost Done!
Make the firing pin.
STEP 9: Step Nine. Finished!
get the firing pin in, and put a rubberband on it. you have to put the rubberband under the front hole. pull the pin back and push it a little bit down, so it leans on the firing pin.
STEP 10: Step Ten. How to Shoot?
not hard. just push the blue rods so the pin is'nt blocked by the top of a connector. Load the ammo in the front. (bb/small green rod)
Don't forget to comment! I hope you like my gun!
Don't forget to comment! I hope you like my gun!
8 Comments
narutome44 14 years ago
tm_m 14 years ago
lord voldamort 15 years ago
sharlston 15 years ago
sharlston 15 years ago
jaycraw 15 years ago
binglebeebop 15 years ago
Dutchj 15 years ago
lol