Introduction: Led Light Saber/ Glow Stick
entry for led contest
Step 1: Parts
3 LEDS (same color), bic pen, pill bottle, 9v battery (not in pic), 9v clip, little switch,1k resistor
Step 2: Solder Leds
solder the leds (+too+) (-too-) add longer leads at the end
Step 3: Add the Switch
add the switch to the positive of the leds and 9v clip and put the cathode(- of the led) to the - part of the 9v
Step 4: Done/ Diagram
put it all in the bottle and your done!!!!!!
10 Discussions
12 years ago on Step 4
if you want to get a little more technical you can add a diode in order to help prevent the improper battery hook up. LEDs are forward-biased. also make note: if anyone buys LEDs new, the 2 leads on them are identified by their length. the long one is the positive and the short one is the negative. If they are from wires then the white or black wire is the negative. All other wire color are positive.
12 years ago on Introduction
Good use of extra parts!
12 years ago on Introduction
Small, easy, and cool! You might want to add in a resistor to keep the LED from burning out fast, but this is an awesome idea! (added to favorites)
Reply 12 years ago on Introduction
i did i forgot to put that in the how to
Reply 12 years ago on Introduction
I didn't see it there earlier. And theres no resistor in the images. :-O
Reply 12 years ago on Introduction
O_o and 1kohm is way too much! use a 470 ohm resistor , since the resistor is mostly a currnet limiter
Reply 12 years ago on Introduction
that is what i had to use
Reply 12 years ago on Introduction
I was wondering the same thing. 1k? Wow.
12 years ago on Introduction
dang its a little similar to what i made ages ago wen i pulled out hte guts of a lighter i had with a blue led in :) I got a plastic tube a little bigger than the battery stack (3 button cells) and a button pusher from an old laser pointer. made a hole for it, pushed the bits in and added a roll of tracing paper to diffuse and capped the end with scotch invisible tape (its like the tracing paper). then wrapped black tape round the bottom where the led and battery's are.. its kool :) and bright, i use it to see at night wen getting up for bathroom or im power cuts cos its im my pocket all the time.. very usefull :) was toying with the idea of making another simpler one as an instructable..
Reply 12 years ago on Introduction
sounds cool please put that up i want to make one