Introduction: LittleBits Halloween Prank

By

This fun little project is just in time for Halloween. Use this project to scare or amuse your friends when they get too close to your treat bag.

Step 1: Gather Your Materials

Craft Materials:

Medium sized novelty pumpkin (we found one at the dollarstore)

Cardboard

Tape

Glue gun and glue

LittleBits:

Power block, button, buzzer, servo motor, 1 orange wire, RGB light


Step 2: Assemble Your LittleBits

Assemble your littleBits in the following order:

Power block, button, buzzer, servo motor, 1 orange wire, RGB light

Step 3: Attach Your LittleBits

Tape your RGB light to the front of your pumpkin where the jack-o-lanturn's face is located.

Tape a circle of cardboard to the servo motor, then hot glue the cardboard to the bottom of the pumpkin.

Step 4: Attach Your Pumpkin to the Table

Attach the servo motor to a table using tape and enjoy scaring your friends :)