Introduction: Making of Table Top Water Fountain
More by the author:
About: hobbyist in DIY electronics
making of table top water fountain is not an easy job but u can get an idea of making it by following my steps.
you need:
1) m seal
2) 12v motor (used in tape recorders)
3) plastic round cap
4) plastic wheel (to fix in the fan)
well here m seal is a wax based gum u can mold the gum as u like. i masked a fan u can see in the pitcher below it is used in the pump
http://youtu.be/F5xPI9pDNvo
you need:
1) m seal
2) 12v motor (used in tape recorders)
3) plastic round cap
4) plastic wheel (to fix in the fan)
well here m seal is a wax based gum u can mold the gum as u like. i masked a fan u can see in the pitcher below it is used in the pump
http://youtu.be/F5xPI9pDNvo
Step 1:
12 volt adopter is used for safety purpose
Step 2:
<iframe width="560" height="315" src="http://www.youtube.com/embed/F5xPI9pDNvo" frameborder="0" allowfullscreen></iframe>
Step 3: