author
1Comments

Tell us about yourself!

  • Modifying 120deg viewing angle infrared rear view camera

    Hi everybody.I appreciate that this is very old post however I have solution that could help to remove these annoying grid lines on some parking cameras. Before I start I have to say that this could/could not work on some cameras but it is worth to try as it works for me but not with all cams. There you go- I bought many different parking cams as I wanted to install them as CCTV- mainly because they are small and have a wide viewing angle. Once connected I found that grid lines are too annoying and started to playing around to remove them. Solution is very simple.Every cam once opened have three wires going to board. Yellow, Green, Red. All you need to do is 1.) Turn the camera power off. (its has to be done otherwise grid lines will not going to disappear)2.) locate GREEN wire 3.) conn...

    see more »

    Hi everybody.I appreciate that this is very old post however I have solution that could help to remove these annoying grid lines on some parking cameras. Before I start I have to say that this could/could not work on some cameras but it is worth to try as it works for me but not with all cams. There you go- I bought many different parking cams as I wanted to install them as CCTV- mainly because they are small and have a wide viewing angle. Once connected I found that grid lines are too annoying and started to playing around to remove them. Solution is very simple.Every cam once opened have three wires going to board. Yellow, Green, Red. All you need to do is 1.) Turn the camera power off. (its has to be done otherwise grid lines will not going to disappear)2.) locate GREEN wire 3.) connect small piece of wire to existing green wire or solder your wire where GREEN cable meets board4.) connect other end to one of microchip pins. !!! Don't be afraid- theres is nothing to burn. I did it many times and few cameras are still working as CCTV without grid lines). Keep trying one pin at time. Turn the power on. If lines are still there- turn power off and try another pin until you will find them gone on turning on power on camera.That's it- simply connect GREEN wire to one pin.Sorry I can't attach photo- it's invalid for some reason but good luck to you all.

    View Instructable »