author
3CommentsJoined September 27th, 2018

Tell us about yourself!

Complete Your Profile
  • How to Update the Firmware on a Cheap USBasp-Clone

    Thank you for a most awesome guide:-). I had to swap pins 11 & 12, but I did have a copy Arduino Nano based on the 328P, with a CH340 USB interface. My ASP was exactly same as your BAITE one described here, and because if this @RussellA26 the direct connection will not work!My ASP now takes 2 seconds to upload a HEX, whereas before it took a staggering 10 seconds to upload the same HEX, got to love 1.5MHz! Yip Yah!

    View Instructable »
  • Andromeda45 commented on mecanicafina's instructable Spot Welder 1-2-3 Arduino Firmware7 months ago
    Spot Welder 1-2-3 Arduino Firmware

    Hi, That is the best best anwser ever! It had me in stitches for ten minutes on and off:-)! I was looking up floats last night, as I think I was on the right track, but eventually ran out of steam so to speak. I followed up today - after I could breath, and found that if you add " (int) " - "oled.print( (int) readDefault(activeProfileNumber, i-1));", you do actually get no decimal place! Just need to now find the sub menu elements and hopefully apply the same. I might just add some over temperature sensor protection, but am working on that. I am thinking of swapping over to the adafruit 128X64 library, but I have assumed you used the ASCII driver etc because of the lower memory(both storage and running memory) overhead in overall compiled hex?

    View Instructable »
  • Andromeda45 followed LEGO, Reuse, Electronics, USB and 6 others channel 7 months ago