Tell us about yourself!
MyPetBot (A Bot That Follows You)
Yes that's a good idea, in fact recorder can be made to record statistics on predefined interval , which can be later viewed for bettering the track time against various odds
Save Water & Money With the Shower Water Monitor
Impact Recorder for Vehicles
Impact Recorder for VehiclesView Instructable »
Well in my case, i did a careful drill to back of screen , wherein i screwed the inverter and controller, but make sure not to damage the LCD screen, the drill can be just to have two or greater threads and is suficeint enough to hold the inverter
Hi , didn't see ur comments, hope the issue is resolved
MONITOR YOUR GARDENView Instructable »
Well, from the pics attached, it seem IBM panel, you can look for part no i.e P/N ,for your model it is 03L5060
well in that case renewable solar energy can be explored, as the espduino can be powered by 9V battery as well
Arduino Weather StationView Instructable »
I have connected both PI 2 and B+
Programming a HTTP Server on ESP-8266-12E
Haute Couture Choker With Beaded Roses
yes..thats great :) !!
Wire Wrapped Copper Ring
The Copper rings looks great and with weaved design, i hope its more resistant to heat too.
Hiwell, yes resistor rating is important, typically resistor with same wattage rating may have different ohmic value, so instead go with the ohmic value. Add 1k ohm resistor between the echo pin and GPIO as in above. (To know resistor is 1k, you can refer to colour coding chart or measure with multi-meter).Waiting for sensor is due to improper value at Echo pin.Let me know, if you face further trouble, if any.
The Engineering Crash Course (for Makers)
Nice instructible for getting started, it would be nice to include ever expanding new MCU in future.
Thats great :) and yes a step down dc-dc converter could serve your purpose for single power source.
Yes, i agree with you, but to keep cost down you can locate one from ebay, i got my one for only 12$ for 15.6 inch screen , further to keep cost down for controller board choose the one with only required ports, i.e many controllers boards are available with VGA, HDMI, DVI etc ports, but for connecting raspberry pi, only VGA port is sufficient.
I wld be happy to judge more of tech stuffs
Home Raspberry pi Desktop with old laptop screenView Instructable »
Line Follower Robot - PID Control - Android Setup
Agent KK : Defend Your Room From Unauthorized Intruders!
Arduino Person Counter
The ESP8266 Part 1 - Serial WIFI Module for Arduino
Simple Pi Robot
How to make a drone for under 120$