Tell us about yourself!

Complete Your Profile
  • BilbobC commented on darren8306's instructable Simple Prybar for pallets3 years ago
    Simple Prybar for pallets

    It would most likely be to expensive to send in the mail it is a heavy piece or work with a long steel handle.

    View Instructable »
  • BilbobC commented on darren8306's instructable Simple Prybar for pallets3 years ago
    Simple Prybar for pallets

    I followed the instructions and looked at the photos. It was simple enough for me. I'm not the best welder but this mother is still strong. I added end caps after reading about one guys unit bending. Truth is his handle is in the wrong place see original photos for that. I've added a few photos from different angles so you can see the end caps however I don't think they were necessary. I used 3/16" metal bar its what I had on hand. Recycle when you can that's the point behind this whole exercise anyway. You could put hockey tape on the upper handle just work it as is.

    View Instructable »