CombatRobotGuy15

Thanks! If you like this stuff I would recommend subscribing to my YouTube channel: https://www.youtube.com/channel/UCgO0GEN4iXCauXte8O-5n2w

Have at it!

Very nice instructable, I had a few questions after reading it though. I am looking to design a PCB board which is essentially 2 brushed escs, like this: https://www.amazon.com/YoungRC-Brushed-Motor-Speed-Controller/dp/B07L2T6MHB/ref=sr_1_11?dchild=1&keywords=brushed+motor+and+esc&qid=1610395706&sr=8-11, and a brushless esc all in one circuit board to maximize space and efficiency for a project. Is this possible/how hard do you think that would be to create?

To my knowledge, Combat Robot Kits has their website undergoing renovation, so that’s why the links aren’t working, though I would recommend a starter kit which provides the basic parts and electronics for the combat robot (antweight 1 pound): https://www.etsy.com/listing/753628264/combat-robot-battlebot-starter-kit?ref=shop_home_active_4&frs=1&crt=1Or a 150g combat robot kit like this one: https://www.etsy.com/listing/920431649/battlebot-kit-combat-robot-kit-l?ref=shop_home_active_2&frs=1Hope that helps!

Thank you!

Looks great!

How much did this cost to make (Landed)?

I built a 3d printed instrument a while ago and the strings put ways to much compression onto the instrument without other supports (carbon fiber rod, etc). Is this why there is no finished product? If so I might be able to help.

Please be patient with this Instructable as I am Rebuilding and improving, since I cannot unpublish this, I though it was best not to have anyone build it, and then run into the same problems I am battling now.

Please be patient with this Instructable as I am Rebuilding and improving, since I cannot unpublish this, I though it was best not to have anyone build it, and then run into the same problems I am battling now.

Thank you!

This is my favorite instructable of all of them I have seen yet

Nice!

Where did you get the pulley and pulley hubs from?

This is just great

Wouldn't it be more practical to design this not on a door?

Thanks for the feedback! I will defiantly take it into consideration, but my hesitation is I would still like super quick and easy removal. I'll check it out though.

Amazing!

Any questions and I will be happy to help!