Tell us about yourself!
- Finecutpost commented on GlytchTech's instructable Ebike Upgrades: SLA Battery Wiring and Charging
- Finecutpost commented on musefablab's instructable Circuit Making: The WorkshopView Instructable »
Hi All, I'm new to this so if I have put this in the wrong place please advise me where I can get help with this issue.I've got an electric bike with a Hall Effect throttle which outputs .8 to 4.8 volts as it should. However the motor dosn't start running until see 1.4 V and my motor is at full throttle when the Hall output is around 3.8 V This gives me a very limited range on the twist grip so I'd like to build a circuit that outputs 1.3 to 3.8 over the whole throttle range. The controller is a Golden Motor programmable unit and I've built the restrictor circuit shown in the picture attached
Hi All, I'm new to this so if I have put this in the wrong place please advise me where I can get help with this issue.I've got an electric bike with a Hall Effect throttle which outputs .8 to 4.8 volts as it should. However the motor dosn't start running until see 1.4 V and my motor is at full throttle when the Hall output is around 3.8 V This gives me a very limited range on the twist grip so I'd like to build a circuit that outputs 1.3 to 3.8 over the whole throttle range. The controller is a Golden Motor programmable unit and I've built the restrictor circuit shown in the picture attached