8CommentsJoined November 10th, 2009

Tell us about yourself!

Complete Your Profile
  • Fretless commented on JON-A-TRON's instructable 3D Printed Linear Motion11 months ago
    3D Printed Linear Motion

    What all would I need to do to the design if I only wanted a 1/2" travel area?

    View Instructable »
  • Fretless commented on tomatoskins's instructable Light Up Drum Kit2 years ago
    Light Up Drum Kit

    Yeah, I was wondering about that, I know if I didn't want to use a pot I could use two resistors one going each way, but using a pressure resistor is different entirely.

    I am building a project just like this for the drummer in my band, I was wondering, is it possible to use a pressure sensitive resistor in place of the sensitivity pot? I figure I'd probably need to connect another resistor to ground in order to make it work though. Thoughts?

    View Instructable »