Tell us about yourself!
The screw size for the bearing screw appears to be an M3 x 0.50 (metric) screw. This fit for me!
I made it, basic for now, but i'm on the road to fun! Thinking of making a display for the NEXRAD radar from Miami.
Retrying the video upload for the SMT Kit. Shot on an iPhone, so it's a MOV file. Soooo blinky!
SMT you say? :) Recommendations: 3x readers or a magnifier. A smaller tip on the soldering iron and small solder (say 1/32 or smaller size) and use liberal amounts of flux. You can use MEK (home depot) or flux remover later, then remember to use isopropyl alcohol to clean the MEK off the board, etc. White LED added from lab, because 'merica :)
There is a misplaced bar in the design, so please not that you may need to remove the retaining bar on the inside of the box on the floor
Here is the Thingiverse Link for the power supply box I designed earlier:http://www.thingiverse.com/thing:2224584
I'll try to get it up tonight. Never have uploaded to thingiverse yet :)
I decided the power supply needed a box... So here it is, about to head to 3D printing! Upload to thingiverse coming, designed in Autodesk Fusion 360
Did the Arduino step first! :) So cool to have a breadboard arduino :D
True random number generator, based on ring oscillators. All done with Quartus Prime, graphical entry. The kit is excellent, very clean and no useless extras :) Remember to set Pin 50 "Beeper" to "1" to shut down the beeper in your designs!
A true-random number generator based on ring-oscillators. Nice little dev kit, clean and simple without extra junk to deal with. Remember to set the beeper I.O pin (pin 50) to "1" so the beeper goes "OFF"!