Harsh Dethe

Most samsung phones come with Exynos pocessor which are not very developer friendly. Thus they do not support Gcam.

If your phone has camera then it should be there. If not make one.

Should work fine with both. This trick is irrelevant now as almost all smartphones come with EIS.

Maybe your remote is encoded differently.

Yes sorry for that. I didn't pay attention.

NodeMCU uses software PWM and all GPIO pins support that.

Please go through the instructable carefully.

Yes you can.

yes because it takes each character sepatately.

This tutorial is clearly for Arduino and you are tyring to uplaod it to ESP8266 Board.

The tutorial is for Python 2, you are using Python 3.

I didnt use library because I codded it raw.The actuator is going both sides but the rudder I made wasn't good enough for it as it was restricted on one side.

Awesome!!!Make sure you check out my instructables for other amazing projects.

Sure, You will have to make some changes in syntax but it should work. I am planning on posing a new instructable about this project using Python3.

All most all smartphones now have EIS. If you still want to do this, make sure your phone is rooted.

Very nice.Do check out my other projects based on NodeMCU.Hope you like them.

Make sure you have selected the correct board and the right port.

Have you selected the right board in tools?

Make sure you have written the correct code.

First, make the sensor point to wards the remote.Make sure the sensor you are using is connected properly.Also, is the remote IR or RF, it should be IR in order to work.Check to see if the remote is working, You can see the LED on remote through a mobile camera and press any button to check if the light blinks.