Tell us about yourself!
you are most welcome!!!
Good to hear that !!!
for the graphic test, please redeclare and activate the lower part. Make sure uncomment pin rewiring and make sure put voltage divider for DC, CS, MOSI,CLK and MISO/// kenedeclare dulu#define TFT_DC 9#define TFT_CS 10#define TFT_MOSI 11#define TFT_CLK 13#define TFT_RST 8#define TFT_MISO 12// Use hardware SPI (on Uno, #13, #12, #11) and the above for CS/DC//Adafruit_ILI9341 tft = Adafruit_ILI9341(TFT_CS, TFT_DC);// If using the breakout, change pins as desiredAdafruit_ILI9341 tft = Adafruit_ILI9341(TFT_CS, TFT_DC, TFT_MOSI, TFT_CLK, TFT_RST, TFT_MISO);
No, dont use radio as the distance sucks
Esp8266 firmware update
It is not so smooth. How can we make it smoother?
Please check whether it is full step or not?
i'm glad that i could help you. My pleasure to hear that
sorry, don't know what decay setting.. maybe you talk about delaymicroseconds
the code should work easily, simply change delayMicroseconds(100) to delayMicroseconds(analogRead(A0)) ... if you use analog pin A0 and so on
sorry, i never try.
connect to analogpin in Arduino. Then you use analogRead to read the value of potentiometer. Replace the value of delaymicroseconds with the analogRead reading and huwala, you can control the stepper speed. But, you may need to divide with some value as analogueRead may go to 1023. this will slow down your stepper a lot.
NIce one, I would prefer to use A4988 Pololu driver rather than a TB6560 which is overkill
2W Arduino Laser Engraver/Cutter
Wireless 3D Printing
Simple and Impressive Business Card Printer