Tell us about yourself!
Very useful. Thank you!
Thanks for notifying us about the existence of this page and these customizable enclosures. Very useful! Be well!
Thanks for notify us about the existence of this page and these customizable enclosures. Very useful! Be well!
Interesting Instructable. May I ask which op-amp you used?
Is it possible to make this work with the current FabGL VGA library?
My friend, I made it!!! It is working fine! At first, it didn't work, I believe the resonator I used (taken from some PCB I found in trash) wasn't 8 MHz. I altered the fuses for the ATTiny85 to use it's internal clock at 8 MHz and it worked OK!
Hello,I am sorry, but the instructions for the connections aren't very clear. Can you explain them in a more understandable way?Your instructable seems very good, and I would like to make it.Thank you.
My friend, your instructable helped me to make a power supply for an Amstrad 6128. Once I saw the pinout where you mentioned "the pink (sometimes smaller gauge red)", I knew what the problem was, and indeed the supply finally worked! Be well and a big thank you from me!
Atari Like USB Paddle Using Arduino LeonardoView Instructable »
OK, thanks for your answer!
Yes, but after you program the OTP bit, can you still be able to also boot from an SD card again ?
Hello,You say 1.5708*height for the height but in the picture the number is slightly different. Isit due to a tounding of the number ?
Thanks for the quick answer!