Tell us about yourself!
Repairing Landcruiser Tank Changeover Solenoid View Instructable »
Mangoe Smoothie/icecreamView Instructable »
Hi nekkidnorman, do you have a link to the standards you referred too?
Chainsaw Tool HolderView Instructable »
Hi, thanks for feed back. I added a paragraph that states I cannot advise adding anything to concrete as I don’t know anything on the subject and read instructions of any product you intend to add. I also have added a pic of the bolts I used. Cheers
Hi, I just added a sentence to remind people to check local building codes. Thanks
Concrete Step TreadsView Instructable »
Painting CCTV CamerasView Instructable »
I can’t figure out to update this page from my phone but want to add a really simple way to remove the flywheel. 1. Step on loosen flywheel nut. Leave it on a couple of threads. 2. Ensure a nut it on the pull start end to protect threads. 3. Holding engine flywheel side down, strike the pull start end of the crank with a hammer. Make sure to strike it true so all the energy is transferred to the shaft and down. Flywheel should pop off after a couple of strikes. Picked this up working on chainsaws and it works a treat. Very little effort and a lot easy than using a puller. Cheers
Resin Fish Table View Instructable »
Honda GX25, Part 3: Rebuilding View Instructable »
Portable Rotary Epoxy Fly DryerView Instructable »
Honda GX25, Part 2: Porting and ModsView Instructable »
Stripping Honda GX25View Instructable »