Tell us about yourself!

Complete Your Profile
  • MichaelS1175 commented on ehsmaes's instructable Motorized WiFi IKEA Roller Blind5 months ago
    Motorized WiFi IKEA Roller Blind

    Any one else get the panic/watchdog reset all the time?================== ==================ESP8266 mode is: 1MAC address is: 62:01:94:45:db:84IP is 192.168.0.149====================================Warning, deprecated API! autoreconnect == 1 is deprecated. It will be removed in the next version. See documentation for details.PANIC: unprotected error in call to Lua API (button.lua:23: attempt to perform arithmetic on upvalue '?' (a nil value)) ets Jan 8 2013,rst cause:4, boot mode:(3,6)wdt resetload 0x40100000, len 26524, room 16 tail 12chksum 0x7eho 0 tail 12 room 4load 0x3ffe8000, len 2184, room 12 tail 12chksum 0x6bho 0 tail 12 room 4load 0x3ffe8888, len 136, room 12 tail 12chksum 0x97csum 0x97„âìƒoä›r‚ûo|ìdld$`cÛž|{’...

    see more »

    Any one else get the panic/watchdog reset all the time?================== ==================ESP8266 mode is: 1MAC address is: 62:01:94:45:db:84IP is 192.168.0.149====================================Warning, deprecated API! autoreconnect == 1 is deprecated. It will be removed in the next version. See documentation for details.PANIC: unprotected error in call to Lua API (button.lua:23: attempt to perform arithmetic on upvalue '?' (a nil value)) ets Jan 8 2013,rst cause:4, boot mode:(3,6)wdt resetload 0x40100000, len 26524, room 16 tail 12chksum 0x7eho 0 tail 12 room 4load 0x3ffe8000, len 2184, room 12 tail 12chksum 0x6bho 0 tail 12 room 4load 0x3ffe8888, len 136, room 12 tail 12chksum 0x97csum 0x97„âìƒoä›r‚ûo|ìdld$`cÛž|{’lœnà‚nâ

    View Instructable »
  • MichaelS1175 commented on ehsmaes's instructable Motorized WiFi IKEA Roller Blind5 months ago
    Motorized WiFi IKEA Roller Blind

    Hi!Trying the "Dry-run" to see if the motor can spin but it seems that there is some issues when I change the GPIO pins for the motor. I have a custom made card where the pins are fixed to:* A: = GPIO 16 * B: = GPIO 14 * C: = GPIO 12 * D: = GPIO 13stepper_pins = {16,14,12,13}Any tip on the error-message below? step_move(1000,FWD,2)stepper.lua:36: bad argument #1 to 'mode' (Invalid pin)stack traceback:[C]: in function 'mode'stepper.lua:36: in function 'pins_enable'stepper.lua:64: in function 'step_take'stepper.lua:91: in function 'step_move'stdin:1: in main chunk

    Never mind, my mistake in reading how the GPIO are named :-)stepper_pins = {0,5,6,7}

    View Instructable »