Motaz Bany-Amer

first I have to ask you, are you sure you have uncommented the Mega board definition of the mega board in "HW_AVR_defines" library, and saved your edit!. can you tell me if the LCD worked before or is this the first try?if you are sure you have followed the steps correctly, then I only can presume that there is a disconnection or some damage in your tft.. to check this...please try to use another arduino board, you can use an uno board or mega.if possible please try to use another LCD..please try to press a little hard on the area marked with red in the picture, there might be a disconnection in these pins or beneath, it happens, and it happens to me once...I had this kind of problem many times, most often I find the error in the pins set.. so please double check it...one last…

first I have to ask you, are you sure you have uncommented the Mega board definition of the mega board in "HW_AVR_defines" library, and saved your edit!. can you tell me if the LCD worked before or is this the first try?if you are sure you have followed the steps correctly, then I only can presume that there is a disconnection or some damage in your tft.. to check this...please try to use another arduino board, you can use an uno board or mega.if possible please try to use another LCD..please try to press a little hard on the area marked with red in the picture, there might be a disconnection in these pins or beneath, it happens, and it happens to me once...I had this kind of problem many times, most often I find the error in the pins set.. so please double check it...one last thing I can think of, that you are using a different module from the one I used in this instructable, if so you have to change the model name "model for utft()" and you might need to change the pins set too...please tell me if any thing worked with you :D