Tell us about yourself!
Entry level DIY CNC TDKU I
Hello,After having built two 1-Player bartops (see below previous post, Metal Slug and Spiderman), I built two other ones for friends, but 2-Players this time. The chosen theme were Metal Gear Solid and Street Fighter.This instructable was really inspiring me :-). Once again, thanks!
Hi! For the first question, I'm sure of it. For the second, I was wondering the same. In fact, this is a cheap AM found on the net, without a lot of explanations. I tried many different ways to cable it, and I think I burned it... I should try with a new one.Thanks for the advices!
A friend of mine did it with Metal Slug images found on the net, and using inkspace / gimp to build it.
Yes, I verified it, it is connected as it should normally be: in the current line (not in parallel) as it should contain a built-in shunt resistor. But I'm not so sure about it. And I have no real info on the product. So, it is of course a wiring issue, but which one...
Hi, I just painted it as I used 12mm MDF. The result is more than acceptable if you sand it correctly.
Hi, thanks! Yes, no problem to share. Could you MP me with your email adress? I'll send it to you.
2-Player Bartop Arcade Machine (Powered by Pi)
Variable ATX bench powersupply - FabLab edition