Nematic!

I would love to judge circuit category

PDF is already attached

not tested

Always trying to make projects connecyed to each other :)

Your disply is I2C you dont have to do anything just use standard I2C 4 pin config

Looks great!

Happy to Help :)

This is a 16 bit oled you can't use I2C with it, but however, you can use it in 3 pin SPI mode just short BS0 jumper

Currently on my wish list I need an oscilloscope but can't afford right now. If I have one it would be much easier for me to make good educational videos and projects.

Yes you can control it via phone.

BMS is mandatory if you use more than one cell in parallel and if you know what you are doing then it's fine.

thanks

Nice Project mate

I have mentioned that in step 2

definitely can be done but working around such ATX supplies for beginners is not a good idea becaues of capacitors

I had to buy them in pair so just saved few bucks there :p

Hi support sent me here I recently posted an instructables Link- https://www.instructables.com/id/DIY-Arduino-Nano-/It was not featured despite have good picture, step by step instructions and more over it has got plenty of views. I don't know what's wrong with my post let me know.

Thanks and all the links are working

2nd bridge is not mandatory you can remove it

yes it will work, just make sure you are using right wattage resistor

10ohms

would definitely look cool in parties

Thanks

That's great tutorial, but you can add much more info about scrolling text and other stuff

Really cool project !

Great project!

Building a Tesla coil would be easier now

Good tutorial, Next time use new solder bit