Neodyme

That's a good question !The device is not able to show the status of the battery (but the battery module will prevent the battery from over discharge). It should be possible to connect a small analog to digital converter on the GPIO of the Raspberry :D

Hello,The STL files are here : https://www.thingiverse.com/thing:3230073Remember that's a simplified representation of the printer not a perfectly accurate 1:1 copy of the printer parts.Send me a PM with your email if you need the F3D files :D

Thank you very much !!!It is the most useful guide about this board

Because it's the name of the skin in the game ;)

Thanks

Thanks ;)

Hi :D Thank you for your interest. 1) The term "Sheet rubber" was the only term that I found to describe the product that I used :p (I'm Belgian, my English level isn't' excellent).I simply used an anti-slip mat for car. I have no information about the proprieties of this material.2) I used "classical" transparent contact glue (neoprene or something like that).I hope that helped :D

Thanks !

The only problem is that the battery life is the same as for a real iphone XD