Tell us about yourself!
- NorbertoB3 commented on getburnt's instructable Arduino Laser Engraver
- NorbertoB3 commented on zeropt's instructable DIY MOSFET Motor ControllerView Instructable »
i am looking forward to taking this design and coding my own rc vehicle one day, i will be looking in my tacle box for some mosfets and that box thingy, i have a few of those from salvaged hardware...
- NorbertoB3 followed acrobotic
By acrobotic
- NorbertoB3 commented on acrobotic's instructable Upgrading Smart RGB LEDs: WS2812B vs. WS2812View Instructable »
In step 1: list of materials I did see there was a ws28xx led bit loose from it's breakout board, was hoping you can tell me what the resistors on those 2 other tiny boards are for, it's purpose and what line is it connected to? I just can not seem to find a clear answer on that little bit sitting there...
- NorbertoB3 commented on ldevendorf's instructable Become Your Own 3D PrinterView Instructable »
if you can get the gps to sync then tell you were the laser is pointing and the cordinates estimated by were ur geo location? would be nice tool cor photo info of far off views
is the pot 5k ohm or 5 ohm? seems hard finding 5ohm pot at 15 watt rating....im lost as for all resistors in project...the watts are all dif