Phantom OfT

I don,t own them personally. But I have about 80 left. sell for $4.00apice + shipping, I still have thave account to reproduce too.

You do realize most of your links go no where!

Don't know what happened unable to email you.

I don't consider it point less, others can create their ownboards, I can provide them the web address, or we all can get together and makea large order at the same time. Since I did not have his permission to use hisvideos, I did not provide them, in the instructable.I tried in his comments to make contact with him months ago, no go. As I stated in the instructable, I did not Create it, Designit, the boards. In addition, since I did not own the board, I did not list iton this Instructable. However, But I did provide an Email address at the end ofthe instructable so anyone can contact me and I am willing to provide the webaddress to obtain the Gerber Files. Alternatively, if anyone is willing I willtake orders to generate a large order of 500 boards or more, to get the pricedown for everyo…

I don't consider it point less, others can create their ownboards, I can provide them the web address, or we all can get together and makea large order at the same time. Since I did not have his permission to use hisvideos, I did not provide them, in the instructable.I tried in his comments to make contact with him months ago, no go. As I stated in the instructable, I did not Create it, Designit, the boards. In addition, since I did not own the board, I did not list iton this Instructable. However, But I did provide an Email address at the end ofthe instructable so anyone can contact me and I am willing to provide the webaddress to obtain the Gerber Files. Alternatively, if anyone is willing I willtake orders to generate a large order of 500 boards or more, to get the pricedown for everyone. I have the 4 different versions of the boards Gerber's files.He provided it, I used It. In addition, ifhe contacts me; I am will to acknowledge he created this. Moreover, I will makea supplement to the instructable and enter that information. You have my permission to pass it on to him.

I do not own the rights to them.

Could these be a replacement part or is it imperative that the one you list must be used.The difference is a $4.50 per part compared to $0.27 per part. If these do not replace how about low cost alternative.D3 and D4 are zener diodes 1N821Voltage - Zener (Nom) (Vz) 6.2V Tolerance ±5% Power - Max 500mW Impedance (Max) (Zzt) 10 Ohms Current - Reverse Leakage @ Vr 2µA @ 3V 1N4735A-TPCT-NDVoltage - Zener (Nom) (Vz) 6.2V Tolerance ±5% Power - Max 1W Impedance (Max) (Zzt) 2 Ohms Current - Reverse Leakage @ Vr 10µA @ 3V

can you provide another example of a power supply / the one you show is not available. Or provide exact input and out put specs.

The water filter container does not provide the security from contaminating the vacuum pump. It allows the fluid to be drawn up into the pump which will damage it. a oil / water separator filter for a air compressor would help. By installing this in series with the capture tank with a quick disconnect air connector would work.

Shop vacs Should Never be used on petrol-chemicals Oils, and gasoline, Kerosene, or Diesel Fuel. They will Explode.

It works I have used simulare pumps for removing oil. More for anti-freeze and windshield washer fluids thu. some plastic pumps cannot handle petrol-chemical fluids that's why they have .Ceramic and Metallic pumps for corrosive and petrol-chemical fluids.