Hi Nekhil,We cannot control smd5050 strip with esp8266-01, since this has only 2 gpio pins and we need 3 pins to control RGB pins of strip.
Please check your AUTH token in code and in BLYNK app. Also, look for Serial Monitor under Tools Menu in Arduino IDE, to check if NodeMCU/ESP8266 is connecting or not.
Can you share your code?
Yes, add one more servo.attach(PIN_NUMBER); inside setup() function,considering that you want to control both servos with same slider. Else, create one more Servo variable, read values on another virtual pin from second slider and write this onto the PIN.
For my SG90 servo, Red wire is Vcc, Brown is GND and Orange is COMMAND.
Tools + Materials for 3D Printing
3D Printing Class
Time Scheduled Switch With ESP8266 and BlynkView Instructable »
Control Switch Over Internet With BLYNKView Instructable »
Thanks John, for finding the pointing the issue. I have made some corrections in code(bolded them). Also, select V3 pin for slider. So, now we shall send rotation value to V3 and nodemcu will write this value to D8 pin.I hope this will work fine.
Temperature and Humidity Meter With Blynk AppView Instructable »
Servo Motor Controlled With BLYNK Over WiFiView Instructable »
Make Coca Cola Soda Fountain Dispenser Machine at Your Home Fridge !
Yes, we can sync this with music as well. Will make an instructable for that soon. Thanks!
WiFi Controlled LED Strip With BLYNKView Instructable »
Tools and Materials for Arduino