Tell us about yourself!

Complete Your Profile
  • SaahiU commented on Jnkyrdguy's instructable Making Simple PVC Flutes2 years ago
    Making Simple PVC Flutes

    The dimensions are accurate. And you can check different designing softwares to see what I mean, say flutomat and 'Whistle and Flute Hole Calculator' both calculate different hole separation for same flute.I don't have much tools. I use different sized screw drivers to make initial holes and then use a separate tool to finish the hole so that it ends up as a clean hole. and honestly, I take about 3 hrs making a flute. So, I didn't want to waste 3 hrs of work. That's why I needed accurate dimensions. But I guess that is my last resort now.

    View Instructable »
  • SaahiU commented on Jnkyrdguy's instructable Making Simple PVC Flutes2 years ago
    Making Simple PVC Flutes

    hey JnkyrdGuy,I need your help. I have already made PVC flutes. But the softwares that I use like flutomat do not give accurate dimensions. So I end up making some holes little wider than I want them to be(I prefer .8 - 1 cm dia). Also the higher octave in my flute plays a little off the tune. I have low D scale flute currently.I need Low E flute(indian Scale), In the designer I need to enter Low B as my desired scale(it must be around 65 cms long). PVC specs:- Ext. Dia 25cm, Internal dia 22cm. Need Low B scale(Low E note while 3 holes are open). also I need one with 7 holes, so that lowest note is easier to play.Please see if you can provide accurate dimensions.Thanks

    View Instructable »