Tell us about yourself!
Thank you for this! I needed a 1Hz interrupt for the TinyGPS++ package and this was exactly what I was looking for.
I know I'm late to this party, but thank you for this tutorial!I just tried laser cutting some shapes from veneer, but didn't tape except along the edges to keep the veneer flat against a sacrificial scrap underneath. It ended up that as soon as the cutter was done with a part, the little air nozzle on the cutter head would cause the part to lift up and fly back to the rear ventilation grille, or in some cases just hop over a couple of inches to be sliced up by subsequent laser traversal.How do you keep this from happening?
I'll give that a try, thank you!
Wood Inlay MC Escher Reptiles Motion Art (part 1/2)
Frozen Sea Water Console
Easy Method to Do Laser Cut Wood Inlay
Laser Cut Marquetry